What is the way to connect the X6 d2s and 4 hoppers u2
Moderators: aardvark, davebush, Admin
What is the way to connect the X6 d2s and 4 hoppers u2
I have a X6 D2S azkoyen and four hoppers U2. I need to connect that on paylink, What wires i need or there is a diagram?. Thanks a lot.
Re: What is the way to connect the X6 d2s and 4 hoppers u2
Hi,
As a quick answer, I am assuming the everything operates via cctalk.
You need a 24V power supply for the hoppers, which will also power the X6. The PSU needs to able to supply 24V at about 4 amps. You can either connect this directly to the peripherals or you can use the auto resetting fuse on the Paylink board.
You need to set up each hopper with a different cctalk address - see the hopper manual
You then need to connect all 5 data signals together and to the data pin on the Paylink cctalk connector. This is illustrated on page 21 of the technical extract manual http://aardvark.eu.com/downloads/docume ... xtract.pdf
If you need more detail, then post specific questions.
Dave
As a quick answer, I am assuming the everything operates via cctalk.
You need a 24V power supply for the hoppers, which will also power the X6. The PSU needs to able to supply 24V at about 4 amps. You can either connect this directly to the peripherals or you can use the auto resetting fuse on the Paylink board.
You need to set up each hopper with a different cctalk address - see the hopper manual
You then need to connect all 5 data signals together and to the data pin on the Paylink cctalk connector. This is illustrated on page 21 of the technical extract manual http://aardvark.eu.com/downloads/docume ... xtract.pdf
If you need more detail, then post specific questions.
Dave
Aardvark software developer. Please put all communication on the problem through the board for the benefit of others.