. Or please post, how to setup config file (step by step - filename, how to call and structure/commands in file) for AESWDriver.exe, i have no luck with help : CASSETTE [AT] <Identity> VALUE <Value> [LENGTH <Len1> <Len2>]Change value of cassete to 200 with F56
Moderators: aardvark, davebush, Admin
Change value of cassete to 200 with F56
Hallo, how i can change value to 200 of any cassete with F56. In demo.exe is easy possible, in dispenser panel just change value a status is reassigment and OK, but with .net it not work. . Or please post, how to setup config file (step by step - filename, how to call and structure/commands in file) for AESWDriver.exe, i have no luck with help : CASSETTE [AT] <Identity> VALUE <Value> [LENGTH <Len1> <Len2>]
. Or please post, how to setup config file (step by step - filename, how to call and structure/commands in file) for AESWDriver.exe, i have no luck with help : CASSETTE [AT] <Identity> VALUE <Value> [LENGTH <Len1> <Len2>]The F56 firmware is pre-release, and does not yet pay any attention to the configuration file details.
At power up the cassette values are determined by a pattern of magnets at the front of the tray. We tried to follow the Fujitsu suggested values, the quote from an engineer was: "There are magnets in each box which can be allocated any note values from A-F. If they open the lid of the note box there is details printed inside referenced ?Denomination Magnet Combination?."
That implies that you should put a 0 0 0 1 magnet pattern in your cassette for 200.
The patterns we have defined are
Value Magnets
200 0 0 0 1
1000 0 0 1 0
500 0 1 0 0
100 1 0 0 0
10000 0 0 1 1
5000 0 1 0 1
2000 0 1 1 0
1000 1 0 0 1
500 1 0 1 0
100 1 1 0 0
The top 4 are single magnets, the rest are double magnets.
At power up the cassette values are determined by a pattern of magnets at the front of the tray. We tried to follow the Fujitsu suggested values, the quote from an engineer was: "There are magnets in each box which can be allocated any note values from A-F. If they open the lid of the note box there is details printed inside referenced ?Denomination Magnet Combination?."
That implies that you should put a 0 0 0 1 magnet pattern in your cassette for 200.
The patterns we have defined are
Value Magnets
200 0 0 0 1
1000 0 0 1 0
500 0 1 0 0
100 1 0 0 0
10000 0 0 1 1
5000 0 1 0 1
2000 0 1 1 0
1000 1 0 0 1
500 1 0 1 0
100 1 1 0 0
The top 4 are single magnets, the rest are double magnets.
Aardvark software developer. Please put all communication on the problem through the board for the benefit of others.