Smart Hopper 4

Support for the Milan Intelligent interface, sold by Money Controls as the Paylink USB unit and for the earlier PCI card version.

Moderators: aardvark, davebush, Admin

Post Reply
dlopez
Posts: 3
Joined: Thu Apr 27, 2023 3:19 pm

Smart Hopper 4

Post by dlopez »

Hi,

The smart hopper 4 is supported, I can't get it to work.
Thanks in advance.
Top
davebush
Posts: 482
Joined: Fri Oct 22, 2004 12:20 pm

Re: Smart Hopper 4

Post by davebush »

You need to:
Get the SmartHopper configured in cctalk cc4 mode and check the address is 7
Run the Innov... firmware on the Paylink
Put an entry in Standard.cfg

Code: Select all

SmartHopper at 7
Dave
Aardvark software developer. Please put all communication on the problem through the board for the benefit of others.
Top
dlopez
Posts: 3
Joined: Thu Apr 27, 2023 3:19 pm

Re: Smart Hopper 4

Post by dlopez »

Thank you so much
Top
davebush
Posts: 482
Joined: Fri Oct 22, 2004 12:20 pm

Re: Smart Hopper 4

Post by davebush »

You're welcome.

If you get any further problems post again.
Aardvark software developer. Please put all communication on the problem through the board for the benefit of others.
Top
Post Reply

Return to “Milan / Paylink Interface Support”