Hi,
I have a hopper with a coin acceptor, I try to connect it with cctalk,
activated in Paylink standart.cfg "Smarthopper with Acceptor at 7" .
I connected the Tx pin from Smarthopper to cctalk,
I also waited 2 minutes of the DES key and switched Smarthopper to CCTalk mode and installed innovative firmware for paylink.
But still I have no connection with Smarthopper.
anyone have experience with Smarthopper?
Thx
Smarthopper Acceptor with cctalk problem
Moderators: aardvark, davebush, Admin
Re: Smarthopper Acceptor with cctalk problem
The first thing to check is that the SmartHopper is running in cctalk mode - Innovative should be able to help you to check this.
If you are sure that it is, and the electrical connection looks good, then the next thing to do is to check what Paylink is actually doing.
If you look at this document http://aardvark.eu.com/downloads/docume ... inkLog.pdf it describes how to do a clean reboot of Paylink and then monitor the communications.
In your situation the clean reboot is probably not needed and all you should need do is to get the debugging level communications output to the Paylink log.
If you post what you see, then I can tell you if the Paylink configuration looks correct.
Dave
If you are sure that it is, and the electrical connection looks good, then the next thing to do is to check what Paylink is actually doing.
If you look at this document http://aardvark.eu.com/downloads/docume ... inkLog.pdf it describes how to do a clean reboot of Paylink and then monitor the communications.
In your situation the clean reboot is probably not needed and all you should need do is to get the debugging level communications output to the Paylink log.
If you post what you see, then I can tell you if the Paylink configuration looks correct.
Dave
Aardvark software developer. Please put all communication on the problem through the board for the benefit of others.