Warning Unit selftest failuer code 0

[xagduran]

Hi:
This comes out after sending a signal through an output.
Address f7f7
10: 42: 16.110 Cgffag2 Dgwfdgad Fgt Started PC: Extended Code flag with non zero Address f7f7
10: 42: 16.110 Cgffag2 Dgwfdgad Fgt Started PC: Extended Code flag with non zero Address f7f7
10: 42: 16.251 PC: Extended Code flag with non zero Address f7f7
10: 42: 16.251 Cgffag2 Dgwfdgad Fgt Started PC: Extended Code flag with non zero Address f7f7

[davebush]

Hi,

The USB comms and the real I/O share an 8 bit internal bus. The part that goes "non zero Address f7f7" is an indication that this bus is faulty, usually as a result of an input chip burning out due to excessive voltage.

The Paylink will have to be returned for repair / replacement.

[xagduran]

after reprogramming this comes out
16:07:26.081 PC: Driver start up
16:07:26.191 USB: Unit 0, ID: 0x0403 0xde50
16:07:26.191 Description: Genoa USB Hub
16:07:26.191 Serial No: AE000001
16:07:26.206 Type: Revision 4 (USB Powered)
16:07:26.206 Latency: 16
16:07:26.237 USB2 Ufcfgwf eptefded cgde2 %134744073$ Resefd RequestedPC: Extended Code flag with non zero Address f7f7
16:07:26.237 PC: Unknown Set sub-code e011 received
16:07:26.237 PC: Extended Code flag with non zero Address f7f7
16:07:26.237 PC: Unknown Set sub-code e011 received
16:07:26.253 PC: Memory Reset - new protocol
16:07:26.269 USB2 PC Dafc UpPC: Unknown Set sub-code e011 received
16:07:26.530 USB2 Fg respgfsePC: Extended Code flag with non zero Address f7f7
16:07:26.530 PC: Unknown Set sub-code e011 received

[davebush]

The part up to
16:07:26.206 Latency: 16
is the PC establishing communication with the USB chip, the rest is the internal processor failing to communicate through the USB chip

[xagduran]

And that may be, the paylink is all the mouse with the red light on, it seems that it is not going, will it be damaged?
Greetings.
Angel.

[davebush]

The Paylink unit has failed.

It will have to be returned for repair / replacement.