Aardvark Embedded Solutions Ltd Support Forum

Hello everyone My setup uses two iPro (ID-003) on paylink, one on interface 1 (header 7 pins) and the other on interface 2 (RJ-45). Each iPro is configured to recycle different denominations, iPro(1) RC1= 5€, RC2= 10€ and iPro(2) RC1= 20€, RC2= 50€. If for any reason, or by mistake, I reset the payl...

Hi everyone I need to register in paylink, the coins loaded manually in the hopper. I do not use a coin acceptor, therefore from my application I manually enter the number of coins that I have entered in the hopper (50, 100, etc.) I've looked in the spec manual but haven't found a function for this ...

Hi Dave



Following your advice, I have tested two JCM iPro-RC with ID-003 with the paylink. As you claimed, the tests have been satisfactory

Now I can start with the integration work in my application using the paylink libraries.

Thank you very much for your invaluable help,


Best regards

Hi Dave


I was unaware that paylynk allows modifications to these options.

I will test it and report the results to you


Thank you very much

regards

Hi dave From what you say I have to connect the two iPro with ID-003 to each serial port of the Paylink, one in the molex and another in the RJ-45 If you look at the configuration file that the serial in RJ-45 only has an option for the acceptor, only the RS-232 of the molex offers the two options o...

Hi everyone


I have the need to use two JCM iPro recyclers with the paylink.

Has anyone tried this combination?
Is it feasible?

Which protocol is better for this case, cctalk or ID-003?


Thanks in advance for your suggestions and advice

Regards