We have an estate of units with full paylink connected to JCM iVizion ID003 bill acceptors via RS232.
The firmware used is GenoaV4-1-12-16 which I believe to be the latest.
the units run fine for ages with no faults but then out of nowhere it will report it's status as 0x4C.
Reseting the paylink board using milandiag.exe causes the status to go 0x4D.
Rebooting everything will return it to 0x4C.
This is happening on multiple units.
I'm adding more logging but wondering if anybody had anything obvious to resolve this or seen it before?
JCM iVizion ID003 Fault 76/77
Moderators: aardvark, davebush, Admin
Re: JCM iVizion ID003 Fault 76/77
Hi,
4C is a bit sensitive general status. The 40 bit says "acceptor fault".
To get more information you need to check the Paylink log file. This is often called Paylink.log and in the folder that hold the driver executable.
If you ignore the lines you don't understand you may be able to read the rest to see what's wrong. If you can't make sense of the log then post it in a reply and I'll check it for you.
4C is a bit sensitive general status. The 40 bit says "acceptor fault".
To get more information you need to check the Paylink log file. This is often called Paylink.log and in the folder that hold the driver executable.
If you ignore the lines you don't understand you may be able to read the rest to see what's wrong. If you can't make sense of the log then post it in a reply and I'll check it for you.
Aardvark software developer. Please put all communication on the problem through the board for the benefit of others.