Acceptor with recycler iCT BR2300 by MDB

[xagduran]

Hi:
We are doing a development with Paylink and we are using the ICT BR2300 wallet with dispenser. The development we are doing in C #. It is connected by MDB.

Everything works perfectly, our application handles them perfectly, but we don't know how to do that instead of going to the drawer, they go to the recycler whenever we want.

There we wAcceptors on the system are:
Acceptor 0: ccTalk Coin - <~~~~>, Serial Number 0,
Default Path 0, Currency <>, 0 coins:
Acceptor 1: MBD Bill - <1978~0~ICT~BR2300-EUR40~0115>, Serial Number -898637388,
Default Path 0, Currency <978>, 4 coins:
Coin 0: <5*1>, Value 5, Count 0, Path 1, Coins 0
Coin 1: <10*1>, Value 10, Count 0, Path 0, Coins 0
Coin 2: <20*1>, Value 20, Count 0, Path 0, Coins 0
Coin 3: <50*1>, Value 50, Count 0, Path 0, Coins 0

Dispensers on the system are:
Dispenser 0: Unknown code 11080001 - <MDB Dispenser>, Serial Number -898637388,
Coin Value 5, Number Paid 0, Current Count 0
Inhibit 0, Address 96
ant to have € 5 bills for change.


Thanks in advance.

[davebush]

Hi,

With the MDB protocol Paylink has no control over what happens to a bill when it is accepted. Paylink just issues the MDB "Stack" command, and the BR2300 decides where to send the bill.

All the control over how the bill is routed to the stacker or the recycler is done outside the protocol.

If you wish to have closer control over the BR2300, then you could consider running it in cctalk mode.

Regards

Dave

[xagduran]

Hi:
Thank you very much for the reply.
Let's try cctalk and we'll tell you.
Thank you.
Greetings.
Angel.