Aardvark Embedded Solutions Ltd Support Forum

Thank you Dave

Hi, I'm trying to create program that handles Hopper and Note Acceptor. In LinuxDemo that is attached to examples I saw that few tasks (e.g. DataFn_UpdateDispensers or DataFn_AcceptorUpdateData) are scheduled with use of g_timeout_add (tasks processed in main thread). Can I run many calls from diffe...

Thank you for help.
Turned out that my power supply was not sufficient for my hopper.
When comes to PayOut, undefined events happend.
I replaced power supply and looks like everything works fine for now

I repeated test (same behavior) and second time there is no Switching to level 2/3/4 cipher entries. Not sure if this remark is crutial. 06 November 2025 Driver:4.1.12.16 09:28:27.873 PC: Paylink Driver startup 09:28:27.873 Driver Thread Started 09:28:27.873 09:28:27.894 PC: Driver start up 09:28:27...

Hi Dave, Thank you for an advice. I followed "Clean Paylink Log" and pasted below logs. Sequence of events: - started Paylink.exe - started MilanDiag.exe with d cct - started Demo.exe - requested payOut 100 - hopper just moved little bit and stuck with payling status 06 November 2025 Drive...

Hi, I have hopper MKII Suzo happ hopper . My issue appears when i would like to PayOut. I use implementation like in Payout example: Execute PayOut then waiting till PAY_ONGOING disappears in LastPayStatus() call. Unfortunatelly hopper just trying for fraction a second to spin a plate with coins and...

Thank you Dave.
I downloaded firmware that is compatible with one roll jcm vega and it works now.

Hi, I face some difficulties regarding establishing transmission between Paylink and JCM Vega 100 Note Acceptor using WalkThrough.exe application. Paylink.log claims : Config: No NV12 / Vega. What should i check to be sure that everything is correctly set-up. This is my electrical connection. https:...