Aardvark Embedded Solutions Ltd Support Forum

Hello Dave,

In US where I send my Paylink for to repar

thaks
Pablo V.

Hello Dave With the cctalk leads not connected to the Paylink board say: 18:43:13.779 PC: Driver start up 18:43:13.873 USB: Unit 0, ID: 0x0403 0xde50 18:43:13.873 Description: Genoa USB Hub 18:43:13.873 Serial No: AE000001 18:43:13.919 Type: Revison 3 (Original) 18:43:13.919 Latency: 16 18:43:13.951...

Hello,

No, dont solve the problem,
to verify that exist current power supply to the connector cctalk 24V, switch power off 12V Paylink,
and checked if there is power in connector 24v cctalk. And yes, there is power.

Do not know what else to do.

Thanks
When I disconnect the power 24V. SR3 still has on green led, I guess PayLink should recognize it.

Sorry anything else

What is that?
19:00:34.900 Failed call to delete

Is because the same error (cctalk: Data Line Frozen) ?

Thanks, my last question:

This happens also if I disconnect the hoppers and leave you only connected the SR3?
Then I understand that the solution would be to replace the power of 24v for the cctalk?

Vilosh

Hello Dave, I configured the file and now the paylink say that: 19:00:34.509 PC: Driver start up 19:00:34.666 USB: Unit 0, ID: 0x0403 0xde50 19:00:34.666 Description: Genoa USB Hub 19:00:34.666 Serial No: AE000001 19:00:34.681 Type: Revison 3 (Original) 19:00:34.681 Latency: 16 19:00:34.712 USB: PC ...

Thanks,
Finally a men replacement two pieces, and work again
The Paylink is well done

Regards
Vilosh

Hello Dave I have a problem finally I start my paylink, and updated the firmware but dont recognize SR3 acceptor and Universal Hopper My Paylink say: 08:50:53.069 PC: Driver start up 08:50:53.225 USB: Unit 0, ID: 0x0403 0xde50 08:50:53.225 Description: Genoa USB Hub 08:50:53.225 Serial No: AE000001 ...

Hello agian Dave

I had kept for four months my PayLink,
when smoke appeared plugged it possibly was wet,
when connecting the device does not turn on any led.
My question is can repair a PayLink?

Thanks and regards

Thanks,

my SR3 model is FB321DED00003,

i hope that the initial configuration was serial

if i have pararel sr3, i can anything else for controller my SR3??

Dave: here I am again with the messages of the interface, some idea? ------------------------------------------------------------------ System Information ------------------------------------------------------------------ AES Intelligent Money Handling Equipment Interface OS Version 5.1 Checking Dri...

Hi Dave, This is the information of paylink when disableinterface() and when enabledinterface() i put in to SR3 $ 0.20 $ 0.10 when disabledinterface and $ 0.10 when enabledinterface() When disabledinterface SR3 continuing reciving coins Look please ---------------------------------------------------...

Hello Dave, I need that you say to me how I can solve the following problem: I have a SR3, and paylink when in my application, the transaction already has finished, i send the instruction: disableinterface(), so that the devices no longer work. But the SR3 continues receiving currencies, later I lef...

Dave, thaks
I already connected the cable and I was re-programmer the Pay link, I used the information of the forum to obtain it.

Regards